Dimplex CS3550 Guide de l'utilisateur télécharger pdf (Page 9)

FIREPLACE INSTALLATION

1. Make sure the units MAIN ON/OFF switch is

switched OFF (refer to operating instruction

section).

2. Plug the unit into a 15Amp/120VAC outlet. If

the cord does not reach, you may use an

extension cord rated for a minimum of 1875

watts.

603

665

226

23.75

8.90

26.18

OPERATION - see Fig. 2

Three switches provide a choice of heat settings. A

switch is in the ON position when the side with the

markings on

(i.e. I, I, or II) is pushed in.

Switch 1 (I) Controls the electricity supply to the

heater and flame effect.

Note: This switch must be in the ON

(I) position for heater to operate with

or without heat.

Switch 2 (I) Provides 600 W heat output.

Switch 3 (II) Provides 1200 W heat output with

switch 2.

FIG. 2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Dimplex CS3550 Guide de l'utilisateur Page 9