Dimplex BF39STP/DXP Guide d'installation télécharger pdf (Page 22)

BF33STP, BF33DXP, BF39STP, BF39DXP

If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs

and heating elements to cool off to avoid accidental burning of skin.

Disconnect circuit power before attempting any maintenance or cleaning to reduce the

risk of electric shock or damage to persons.

TO REPLACE BLOWER MOTOR / BLOWER

(UNIT CAN BE REMOVED FROM WALL)

1. Remove unit from installed wall. (remove trim surround if applicable)

2. Locate and remove both side trims from unit.

3. Remove top panel mounting screws and position heater assembly upright being

careful not to damage any wires.

4. Remove the (3) heater assembly mounting screws from top panel.

5. Remove the (6) blower motor assembly screws and set aside blower motor

assembly.

6. Properly orientate the replacement blower assembly and connect all of the wiring

connections in their original locations.

7. Reassemble in the reverse order as above.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Dimplex BF39STP/DXP Guide d'installation Page 22