Dimplex BFSL33 Guide d'installation télécharger pdf (Page 4)

www.dimplex.com

FRAMING DIMENSIONS

Rough-In Framing Dimensions

Firebox Dimensions

Rough-In Corner Framing

This replace is a zero clearance design. No combustibles can be placed on

the top surface of the replace. Combustibles may be installed to the edge of

the unit. Four mounting anges on the sides of the unit are provided to facili-

tate installation. Insulation and vapor barrier should be placed a minimum of 2”

(5.1 cm) from the unit.

TRIM MOUNTING

This replace comes with three trim pieces, top and two sides. The top piece is

secured with screws at either end and one in the middle. The two side pieces

require a tab to be inserted in the center slot then secured with a screw at the

top and bottom.

SECTION A: INSTALLATION INFORMATION

Figure 1

Figure 2

1 2 3 4 5 6 7 8 9 ... 18 19

Pas de commentaire

Dimplex BFSL33 Guide d'installation Page 4