Dimplex Chesford CSD20 Instructions d'exploitation télécharger pdf (Page 11)

- 5 -

Symptom Cause Corrective Action

The  ame e ect will

not start.

Mains plug is not plugged in.

Switch A is in the ‘ON’ ( I ) position, but

mode Switch B has not been pressed. (See

Fig. 2)

Low water level.

Low voltage connector not connected

properly. (See Fig. 8)

Check plug is connected to wall socket

correctly.

Press Switch B once for  ame e ect. (See

Fig. 2)

Check ‘Low water level’ warning LED ‘E’

under canopy hood. (See Fig. 2). If ‘ON’  ll

water tank.

Check that the connector is inserted

correctly. (See Fig. 8)

The  ame e ect is

too low.

Flame e ect control knob is set too low.

(See Fig. 2)

The water in the sump may be too high

due to the drawer being opened and

closed a number of times, water tank

removed a number of times, or the  re has

been moved.

Metal Disc at the base of Sump might be

dirty (See Fig. 13)

Increase level of  ame by turning Control

knob C clockwise slowly. (See Fig. 2)

If water level in the sump is more than

40mm, the sump should be removed and

emptied in the sink.

Clean Metal Discs with soft brush supplied.

(See Fig. 13) See ‘Maintenance.’ for a step by

step procedure.

Unpleasant smell

when unit is used.

Dirty or stale water.

Using un ltered tap water.

Clean the unit as described under

maintenance.

Use only  ltered tap water.

The  ame e ect has

too much smoke.

Flame e ect setting is too high. Turn the  ame e ect Control knob C

anticlockwise to minimum and slowly turn

clockwise, about ¼ a turn, at a time. Give

the  ame generator some time to adjust

before increasing. (See Fig. 2)

Main lamps are not

working and there

are no  ames or

smoke.

LED ‘E’ Fig. 2 is Lit.

LED ‘E’ Fig. 2 is not Lit.

Follow instructions under Maintenance,

‘Filling the water tank’.

Check the plug is connected to wall socket

correctly.

Switch ‘A’ Fig. 2 is in the ‘ON’ ( I ) position.

Press switch ‘B’ Fig. 2 until you can hear one

beep only, for  ame e ect.

Troubleshooting

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Commentaires sur ces manuels

Pas de commentaire