Dimplex BLF34 Manuel de service télécharger pdf (Page 8)

8 www.dimplex.com

34.1 in.

(867 mm)

19.4 in.

(494 mm)

7.0 in.

(179 mm)

32.4 in.

(823 mm)

30.0 in.

(761 mm)

6.8 in.

(172 mm)

18.0 in.

(457 mm)

16.0 in.

(406 mm)

3.8 in.

(95 mm)

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

Recessed Mount - Partial In-wall

(Figure 7)

Tools Required: Philips head screwdriver

CAUTION: Follow “Preparation for Service” instructions

before proceeding.

1. Remove the decorative glass ember-bed pieces from

the media tray, which lies along the bottom of the inte-

rior Partially Reective Glass. A medium sized con-

tainer such as a bucket or a box will be needed to keep

the glass ember-bed pieces together.

2. Locate and remove the 4 mounting screws located

approximately 3 inches deep in the space between the

outer and inner casing on the left and right hand side.

There are 2 screws per side, upper and lower going

into a stud. (Figure 7)

CAUTION: The replace should be supported while

removing the screws to prevent the unit from falling.

3. Remove the replace out of the opening by slightly lift-

ing and pulling forward.

4. Carefully lay the unit down on a solid at surface with

the front of the unit facing up.

NOTE: If the surface you are using as a work area is a

nished surface that is prone to scratches (i.e. hardwood

ooring), it is recommended that a protective barrier be

used underneath, (i.e. cloth, cardboard, thick plastic).

5. Proceed to the instructions within this manual relating

to the repair being performed - see Table of Contents

for page number.

6. Once repair is complete, reassemble in the reverse

order as above.

Flush Mount – Complete In-wall

(Figure 8)

Tools Required: Philips head screwdriver

CAUTION: Follow “Preparation for Service” instructions

before proceeding.

1. Remove the decorative glass ember-bed pieces from

the media tray, which lies along the bottom of the interi-

or Partially Reective Glass. A medium sized container

such as a bucket or a box will be needed to keep the

glass ember-bed pieces together.

2. Locate and remove the 4 mounting screws inside the

unit located on left and right side towards the front.

There are 2 screws per side, going from the side pan-

els out into the side of the wall stud that frames the

replace. (Figure 8)

CAUTION: The unit should be supported while remov-

Figure 5

Figure 6

Wall Mounting

Bracket

Bottom Support

Bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Dimplex BLF34 Manuel de service Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Dimplex BLF34