Dimplex BFSL33 Guide d'installation télécharger pdf (Page 20)

fl a M e o v e r r i d e sW i T C h Wi r i n g fo r 120/240 vo l T

NOT AVAILABLE WITH NO HEAT INSTALLATION

NOTE: The replace can be wired to have a wall switch operate the heater

independent of the ame.

NOTE: Before installing the unit complete the following:

Install main power connection with appropriate voltage as per Section C •

or Section D.

Install a 2 conductor wire with ground (3 wires total) from the ame over-•

ride switch wall box to the junction box on the unit.

NOTE: Use a wall switch (on/off) that is rated for a minimum of 15 amps.

Loosen the screw securing the junction box cover and remove the cover.1.

Remove the knockouts (if necessary) or use the provided cable clamp.2.

Pull out the three wires marked 3, 4, and G. (blue, blue, and green)3.

Remove the wire connector and separate the wires marked 3 and 4.4.

Connect the (blue) 3 wire from the unit to the (black) L1 wire from the 5.

ame override wall switch by using a wire connector (not supplied).

Connect the other end of the (black) L1 wire from the ame override wall 6.

switch to the L1 terminal of the ame override wall switch.

Connect the (blue) 4 wire from the unit to the (white) Neutral wire from the 7.

ame override wall switch using a wire connector (not supplied).

Connect the other end of the (white) Neutral wire from the ame override 8.

wall switch to the L2 terminal of the ame override wall switch.

Connect the (green) Ground wire from the unit to the (green) Ground wire 9.

from the ame override wall switch using a wire connector (not supplied).

Secure the one remaining (green) Ground wire with a ground screw in the 10.

ame override switch wall box.

Ensure that all connections are tight. 11.

Insert all the wiring of the heater wall switch into the heater switch wall 12.

box.

Insert all the wiring back into the unit and secure with a cable clamp.13.

www.dimplex.com

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

Dimplex BFSL33 Guide d'installation Page 20