Dimplex EWF-SS Manuel de service télécharger pdf (Page 16)

16 www.dimplex.com

PROBLEM CAUSE SOLUTION

Heater Continued

Heater is not turning on Improper operation Refer to Operation Section

Defective heater assembly Replace heater assembly

Defective heater on/off switch Replace heater on/off switch

Heater is turning off after a

couple of minutes of operation

Build up of dirt/dust in heater assembly Clean out heater assembly

Defective Motor Replace Motor

Heater emits an odor Normal Operation Normal operation is when the heater emits an odor

for a brief period after the heater is initially turned on.

The heater is burning off any dust accumulated during

manufacturing or operation.

Defective heater assembly Replace heater assembly

Heater fan turns on but heater

lacks heat

Improper operation Refer to Operation Section

Defective thermostat Replace thermostat

Loose wiring Trace wiring in unit

Defective heater assembly Replace heater assembly

Heating element is glowing red Normal Operation Small glowing sections of the element are considered

normal.

Defective heater assembly If larger glowing sections are causing the heater to trip

the thermal cutout, unplug unit, discontinue use and

replace heater assembly.

Heater fan runs continuously Loose wiring Trace wiring in unit

Defective heater on/off switch Replace heater on/off switch

Defective heater assembly Replace heater assembly

Defective thermostat Replace thermostat

Noise

Excessive noise with the heater

Dirty blower assembly Clean blower assembly

Defective blower assembly Replace heater assembly

Grinding or excessive noise with

the heater off

Moving ame rod hitting or rubbing

against internal components

Ensure rod is straight and mounted properly in the

bracket, spinning freely away from other components.

Replace if necessary.

Defective ame motor Replace ame motor

1 2 ... 11 12 13 14 15 16

Pas de commentaire

Dimplex EWF-SS Manuel de service Page 16