Dimplex EWF-SS Manuel de service télécharger pdf (Page 3)

Remote Control

The replace is supplied with a radio frequency remote

control. This remote control has a range of approximately

50 feet (15.25 m), it does not have to be pointed at the

replace and can pass through most obstacles (including

walls). It is supplied with one of hundreds of independent

frequencies to prevent interference with other units.

NOTE: Before attempting any operation with the

remote, pull the plastic insulator strip out from between

the remote casing and battery cover (Figure 2).

Remote Control Initialization/Reprogramming

If the hand held transmitter or receiver board has been

replaced, follow these steps to initialize the transmitter and

receiver:

Ensure that power is supplied through the main service 1.

panel.

Turn Main On/Off Switch to 2. (Figure 1A).

Within3. 10 seconds press any button on the remote

control transmitter. If the unit does not initialize, turn the

main power switch off for 30 seconds and try starting at

Step 1.

This will synchronize the remote control transmitter and

receiver.

Remote Control Usage

The remote control operates the replace levels

sequentially (from off): ames only; to ames and low heat;

to ames and high heat.

The level is increased every time the ON button is pressed

on the remote control transmitter and the replace can be

turned off at any point by pressing the OFF button.

Battery Replacement

To replace the battery:

Slide battery cover open on the hand held transmitter 1.

(Figure 2).

Install one (1) 12-Volt (A23) battery in the battery 2.

holder.

Close the battery cover3.

Battery must be recycled or disposed of properly.

Check with your Local Authority or Retailer for

recycling advice in your area.

OPERATION

Figure 1

The controls are located on the bottom surface of the

Sahara replace on the right side (Figure 1).

A. Main ON/OFF Switch

The switch has two ON positions marked with

and

“Manual”.

The “Manual” position is for manual operation. In this

position the built-in remote control is by-passed.

The

position is for operating the unit with the provided

remote control.

When in

position the unit is operated with the ON and

OFF buttons of the remote control.

When the switch is in the center position the unit is off.

B. Heater ON Switch

The Heater ON/OFF Switch supplies power to the heater

fan and the heater element. When the switch is in the ON

position the heater operates if the thermostat calls for heat.

C. Heater Thermostat Control

To adjust the temperature to your individual requirements,

turn the thermostat control clockwise all the way to turn

on the heater. When the room reaches the desired

temperature, turn the thermostat knob counter clockwise

until you hear a click. Leave in this position to maintain the

room temperature at this setting. For additional heat, turn

clockwise until you hear the click again and the heater will

turn on.

Resetting the Temperature Cutoff Switch

Should the heater overheat, an automatic cut out will turn

the replace off and it will not come back on without being

reset. It can be reset by switching the Main On/Off Switch

to Off and waiting ve (5) minutes before switching the unit

back on.

CAUTION: If you need to continuously reset the heater,

disconnect power and call Dimplex customer service at

1-888-DIMPLEX (1-888-346-7539).

Figure 2

Off Button

Button

Battery

Cover

Plastic

Strip

Front View

Bottom View

Control Location

1 2 3 4 5 6 7 8 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Dimplex EWF-SS Manuel de service Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Dimplex EWF-SS